SmartNode 4650 G.SHDSL Quick Start Guide
5
Figure 2.
Connecting the SmartNode to the network
1.
You can check the connection with the ping command from the SmartNode to another host on the
local LAN.
172.16.1.99(if-ip)[eth_dsl]#ping <IP Address of the host>
Note
If the WAN address is
not
set to DHCP, to ping a device outside your local LAN you must first configure
the default gateway. (For information on configuring the default gateway, refer to section “Set IP
addresses” in Appendix C, “Command Summary” of the
SmartNode Series SmartWare Software Config-
uration Guide
.)
AC
T
LIN
K
12V
, 1
.25A
–
+
Straight-through wired
or crossover cable
LAN (ETH 0/0)
LAN
WAN (DSL)
Network
