Installing the gateway router
26
SmartNode 4552 & 4562 Getting Started Guide
3 • SmartNode installation
Connecting the power supply
Do the following to connect the power supply to the Model 4552:
Note
Do not connect the power cord to the AC power outlet at this time.
1.
Insert the barrel-type connector end of the AC power supply into the
5V DC, 1.0A
port (see
figure 2
on
page 15).
2.
Verify that the AC power cord included with your router is compatible with local standards. If it is not,
refer to
“Contacting Patton for assistance”
on page 37 to find out how to replace it with a compatible
power cord.
3.
Connect the male end of the AC power supply power cord to an appropriate AC power outlet.
Figure 6. Router front panel LEDs
4.
Verify that the green
Power
LED is lit (see
figure 6
).
The external router power supply automatically adjusts to accept
an input voltage from 100 to 240 VAC (50/60 Hz).
Verify that the proper voltage is present before plugging the
power cord into the receptacle. Failure to do so could result in
equipment damage.
