SmartNode™
Connect a PC, login and configure the IP address
Power Connection and Default IP Configuration
First the SmartNode must be connected to the mains power supply using the included power supply. Wait
until the ‘PWR' LED stops blinking and lights constantly. Now the SmartNode is ready.
The factory default IP settings are as follows:
LAN ports (green, ETH 0/1):
IP Address: 192.168.1.1 Network
Mask:
255.255.255.0
WAN port (red, ETH 0/0):
IP Address: 172.16.40.1 Network
Mask:
255.255.0.0
A DHCP Server with address space 192.168.1.10 – 192.168.1.19 is running on the LAN ports
Both Ethernet ports are pre-configured and active.
If these addresses conflict or do not match with your network they must be changed. Contact your network
administrator if you are not sure what IP address to use in your installation.
PC connection and Login
To access the SmartNode configuration connect a PC with Ethernet port to one of the LAN ports (green) of the
SN4552. Use the included black Ethernet cable for this purpose. Set your PCs TCP/IP configuration to DHCP
to automatically receive an IP address from the SmartNode.
Open a Telnet connection to the default LAN IP address of the SmartNode (192.168.1.1). Use the Terminal
program included with most PC operating systems (e.g. Hyper Terminal on Windows). The CD-ROM also
includes some recommended terminal programs.
The factory default login is
Login name:
administrator
Password: <empty>
So use the name
administrator
after the login prompt and simply press the Enter key after the password
prompt.
login:
administrator
password:
172.16.40.1>
2
