![background image](http://html1.mh-extra.com/html/patton-electronics/onsite-07mos10xx-gs/onsite-07mos10xx-gs_getting-started-manual_4091002038.webp)
OnSite System Installation
38
OnSite Series Getting Started Guide
3 • Installation Overview
9.
Connect the negative lead of the circuit to the “B” power input lead on the OS-10 system terminal block.
See wiring 3-B on
figure 13
on page 36.
Note
The terminal block indicates the “B” power lead by the letter B. This
lead is third from the top on the OS-10 system terminal block.
10.
Secure the wires using cable ties or similar appropriate cable tie-downs.
11.
Turn on power to the DC circuit.
Note
The green PWR (power) LED on the front panel is lit when the sys-
tem receives power from the DC source.
Checking the OS-10 System Installation
When you first apply power to the system, the STAT (status) LED shows a solid amber light. This light indi-
cates that the system is booting. The STAT LED turns to a solid green light when the system completes the
boot process and is ready for operation.
Do not over torque the terminal block captive thumbscrew or ter-
minal block contact screws.
CAUTION