![background image](http://html1.mh-extra.com/html/patton-electronics/copperlink-2168/copperlink-2168_user-manual_4062420009.webp)
9
3.0 INSTALLATION
Because the CopperLink Ethernet Extender requires no configuration, it can
be installed quickly. If you are installing a standalone unit, refer to section 3.1
“Standalone unit installation”. Otherwise, refer to section 3.2 “Rack card
installation”.
Note
If asymmetric transmission or line rates other than 12.5 Mbps
are required , refer to section 4.0, “Configuration” on page 14.
3.1 STANDALONE UNIT INSTALLATION
Do the following:
1. Connect the line interface between the units (refer to section 3.3,
“Connecting the Twisted-Pair Line Interface” on page 11)
Note
See Figure 2 for the standalone unit’s rear panel arrangements.
2. Connect the Ethernet interface (refer to section 3.4, “Connecting the
10/100Base-T Ethernet Interface” on page 12).
3. Connect the power plug (refer to section 3.5, “Connecting Power” on
page 13).
Figure 2.
CopperLink Ethernet Extender standalone rear panel
Po
we
r
Made in the USA
CopperLink
2168/2158
Line
Ethernet
port
Ether
net
Po
we
r
Made in the USA
CopperLink
2168/TB45
CopperLink twisted-pair
terminal block
interface
Ethernet
port
CopperLink twisted-pair
RJ-45 interface
CopperLink twisted-pair
RJ-45 interface
Line
Ether
net