1.0 WARRANTY INFORMATION
Patton Electronics
warrants all Model 2085 components to be
free from defects, and will—at our option—repair or replace the product
should it fail within one year from the first date of shipment.
This warranty is limited to defects in workmanship or materials, and
does not cover customer damage, abuse or unauthorized modification.
If this product fails or does not perform as warranted, your sole
recourse shall be repair or replacement as described above. Under no
condition shall
Patton Electronics
be liable for any damages incurred
by the use of this product. These damages include, but are not limited
to, the following: lost profits, lost savings and incidental or
consequential damages arising from the use of or inability to use this
product.
Patton Electronics
specifically disclaims all other warranties,
expressed or implied, and the installation or use of this product shall be
deemed an acceptance of these terms by the user.
1.1 RADIO AND TV INTERFERENCE
The Model 2085 generates and uses radio frequency energy, and if
not installed and used properly—that is, in strict accordance with the
manufacturer's instructions—may cause interference to radio and
television reception. The Model 2085 has been tested and found to
comply with the limits for a Class A computing device in accordance
with the specifications in Subpart J of Part 15 of FCC rules, which are
designed to provide reasonable protection from such interference in a
commercial installation. However, there is no guarantee that
interference will not occur in a particular installation. If the Model 2085
does cause interference to radio or television reception, which can be
determined by disconnecting the RS-232 interface, the user is
encouraged to try to correct the interference by one or more of the
following measures: moving the computing equipment away from the
receiver, re-orienting the receiving antenna and/or plugging the
receiving equipment into a different AC outlet (such that the computing
equipment and receiver are on different branches).
1.2 CE NOTICE
The CE symbol on your Patton Electronics equipment indicates
that it is in compliance with the Electromagnetic Compatibility (EMC)
directive and the Low Voltage Directive (LVD) of the Union European
(EU). A Certificate of Compliance is available by contacting Technical
Support.
1
APPENDIX A
PATTON MODEL 2085 SPECIFICATIONS
Transmission
Format:
Asynchronous
Data Rate:
Up to 115,200 bps
Range:
Up to 9 miles
RS-232 Interface:
DB-25, male or female (DCE/DTE
switchable)
RS-485 Interface
Options:
DB-25, male or female; RJ-11 or RJ-45 jack;
terminal block with strain relief
Transmit Line:
2, 4 wire unconditioned twisted pair
Transmit Mode:
4-wire, full or half duplex; 2-wire half duplex
Control Signals:
DSR turns “ON” immediately after the
terminal raises DTR; DCD turns “ON” after
recognizing the receive signal from the line;
CTS turns “ON” after the terminal raises
RTS.
RTS/CTS Delay:
8 mSec or “no delay”
Carrier:
The carrier is switch selected either
continuous operation or switched operation,
controlled by RTS
Surge Protection:
600W power dissipation at 1 mS
Power:
Draws operating power from RS-232 data
and control signals; no AC power or
batteries required.
Temperature:
0 to 50° C
Humidity:
5 to 95%, non-condensing
Size:
2.66” x 2.10” x 0.73”
16
