EN
87
CALIBRATE ANGLES
Use an 90° try square to calibrate the
tool. The alignment can be set by the
straight guide locking screws
17
and
the bevel lock knob
19
.
1
RELEASE KNOB
Pull out the release knob
20
to unlock
the saw arm
13
.
To lock the saw arm
13
in lower posi-
tion, push it down and press in the re-
lease knob
20
.
2
MITRE CUTS
Open the rotary table locking knob
16
.
Use the rotary table handle
15
to set
the desired angle for mitre cuts.
There are defaults for 0°, 15°, 22,5°,
30° and 45° in both directions.
1
BEVEL CUTS
Open the bevel lock knob
19
.
1
Set the desired angle and tighten the
rotary table locking knob
16
securely.
Mitre cuts can be combined with bevel
cuts.
2
Set the desired angle and tighten the
bevel lock knob
19
securely.
Bevel cuts can be combined with mitre
cuts.
2
SAW BLADE REPLACEMENT
Press the spindle lock lever
14
and
loosen the saw blade clamp washer
3
with the hex key.
1
Press the spindle lock lever
14
again
and tighten the saw blade clamp wash-
er
3
with the hex key.
4
Caution!
Make sure the tool is
switched off and unplugged and
wear protective gloves.
Place a new saw blade in the tool.
Make sure the rotation arrow points to
the lower front of the saw.
3
Remove the saw blade
12
from the tool.
Do not remove the inner blade washer.
2
Caution!
Observe that the rotation
direction of the saw blade corre-
sponds with the indication on the tool.
Caution!
Make sure the tool is
switched off and unplugged.
PKS210_Kappsäge_Content_V1.0_13-10-11.indd 87
14.10.13 16:24
Summary of Contents for PE-1400 KS
Page 47: ...SV 45 PKS210_Kapps ge_Content_V1 0_13 10 11 indd 45 14 10 13 16 24...
Page 57: ...CZ 55 PKS210_Kapps ge_Content_V1 0_13 10 11 indd 55 14 10 13 16 24...
Page 67: ...SK 65 PKS210_Kapps ge_Content_V1 0_13 10 11 indd 65 14 10 13 16 24...
Page 87: ...EN 85 PKS210_Kapps ge_Content_V1 0_13 10 11 indd 85 14 10 13 16 24...
