Cleaning, maintenance and ordering of spare
parts
Always pull out the mains power plug before
starting any cleaning work.
Cleaning
앬
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
앬
We recommend that you clean the device
immediately each time you have finished using it.
앬
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts of
the equipment. Ensure that no water can seep
into the device.
Carbon brushes
앬
In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician.
Important! The carbon brushes should not be
replaced by anyone but a qualified electrician.
Replacing the drive belt
앬
Loosen the screw and take off the belt guard.
앬
Remove the worn drive belt and clean both belt
discs.
앬
Place the new drive belt on the small belt disc
and, while turning the knife block, pull the belt
over the large belt disc too.
앬
Make sure the longitudinal grooves on the drive
belt are inside the guide grooves of the drive
wheels.
앬
Remount the belt guard and screw it firmly in
place.
Maintenance
앬
There are no parts inside the equipment which
require additional maintenance.
Ordering of replacement parts
Please quote the following data when ordering
replacement parts:
앬
Type of machine
앬
Article number of the machine
앬
Identification number of the machine
앬
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
TECHNICAL DATA
Power supply
230 V - 50 Hz
Rating
900 W
Idling speed ntr
16,000 rpm
Planing depth
0-3 mm
Planing width
82 mm
Rebate depth
0-15 mm
Weight
3 kg
Earthing
II/
쏾
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
L
pA
sound pressure level
87,6 dB(A)
L
WA
sound power level
98,6 dB(A)
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Total vibration values determined in accordance with
EN 60745.
Vibration emission value a
h
= 3,61 m/s
2
Important!
The vibration value changes according to the area of
application of the electric tool and may exceed the
specified value in exceptional circumstances.
GB
10
Anleitung E-HO 900_SPK7:_ 13.12.2007 9:15 Uhr Seite 10
