SCHEMA
DESCRIPTION
1. handle
2. backrest
3. backrest height adjusting bolt
4. handle folding release
5. handle folding release safety clip
6. backrest reclining safety pin
7. backrest
reclining
adjustment
8. seat locking lever
9. seat depth adjusting nut
10. parking brake
11. rear wheel
12. front wheel
13. front wheel direction lock
14. backrest reclining adjustment
15. footrest
16. footrest position adjusting bolt
17. footrest height adjustment
18. safety bar press-pin release
19. safety bar
6
18
10
17
16
15
14
13
12
19
11
9
8
7
6
5
4
3
2
1
20. seat lock safety pin
21. seat interface side holder
22. seat interface front lock
8
20
22
21
9
OPERATING INSTRUCTION
Opening the undercarriage:
Place folded undercarriage on wheels. To open the undercarriage stay between the rear wheels and hold
tightly handle. Move handle up and backwards until the handle folding release is fully locked in its end
position. To check the locking position, move upwards the handle. The undercarriage must not start
folding. Care must be taken to avoid trapping fingers, when opening the undercarriage!
Fitting the seat in the driving direction:
Place the seat exactly into frame seat fittings. By pushing the seat down, rotate the right seat lock levers till
it locks in position, repeat the action with the left seat lock lever. Finally check the seat locking by slight
lifting of seat. Seat must not separate from the interface frame (see picture 1).
Fitting the seat against the driving direction:
Place the seat against the driving direction follow the same procedure like in previous chapter except of
turning the seat 180° to be facing back to front.
Seat reclining adjustment:
Hold the seat tightly. Loose seat reclining adjustment and set the position of the seat. Tighten properly the
adjustment to fix the position. Turn reclining adjustment handle vertically into the safest position by
pulling and rotating.
Seat and footrest set depth adjustment:
T
o adjust the dimensions of the seat and the footrest set position, the seat must be without an occupant and
empty. Loose both seat depth adjustments bolts as well as both adjusting nuts and footrest set depth
adjusting bolt. Set the depth of the seat by pulling or pushing . Tighten properly all adjusting bolts and
nuts.
Backrest height adjustment:
Loose and take off all the backrest height adjustment bolts. Set the height of the backrest by lifting or
pressing down. Assemble and tighten properly all adjustment bolts.
Backrest reclining:
Hold the seat backrest firmly. Loose backrest reclining adjustment and set the position of backrest. Tighten
the adjustment properly.
Footrest height adjustment:
Hold the footrest. Loose the footrest height adjusting bolts. Set the position of footrest and tighten properly
both adjusting bolts. Turn adjusting bolts small handles into the safest position by pulling it and rotating.
Footrest set reclining:
P
ress both press buttons on footrest hinge simultaneously and adjust the angle position of footrest. Free
both buttons and set the position of footrest to allow the hinges to be locked.
Operating the Parking Brake:
To brake the wheels press fully the brake connecting rod. To disengage the parking brake lift fully the
brake connecting rod. (see enclosed picture 2).
Safety Bar:
To fit the safety bar put both ends of safety bar in seat side tubes at once. To take out the safety bar, press
press-pin release and lift the safety bar up.
Getting into the stroller:
Ensure the parking brake is on, to easy getting into the stroller adjust footrest
position as far under the seat as it is possible and fold the footrest base (see
enclosed picture 2); if possible, place the back of the stroller against a wall or
immovable object (alternatively, another
helper may hold the stroller steady); place
child carefully into the stroller, fasten all
3
2
1
3
pic.1
pic.2
pic.3
