PATROLLINE HPS 940, Instructions Manual, Page: 6 / 14

PAG
.6
DI
14 - R
EV
.0 -
COD
.: 00-99-940010
Programmable functions…
HPS 940 can modifies the common features by following this procedure:
1. During the system disarmed (LED off), compose the “secret release code” by the ignition key (see paragraph
“Use of the Secret Release code”). At the end, the indicator lights will quickly flash to confirm that the release
code is correct.
2. Compose by the ignition key the figure 4 (turn on and off the ignition key for 4 times consecutively).
A beep will confirm that the modification procedure is started.
3. Press in the same time the button “A ” and the button “B ” of the remote control.
Maintain the buttons depressed until you get the beeps corresponding to the function you want to modify.
Once reached the position that you want to modify, release the buttons of the remote control. After few seconds:

the LED is ON, it confirms the activation of the corresponding function. Or

the LED is OFF, it confirms the deactivation of the corresponding function.
N° BEEP Description DEFAULT
1 beep Exclusion of Acoustic Signals of Arming and Disarming Disarmed
2 beeps Hazard Signalling Disarmed
3 beeps Acoustic Signalling of Inserted Indicator Lights Disarmed
Check the programmed functions…
It is possible to verify the state of the 14 functions programmed by the acute or deep sounds given by the alarm.
 With the system disconnected (LED off), compose the “secret release code” by the ignition key (see
paragraph “Use of the Secret release code”)
At the end, the indicator lights will quickly flash to confirm that the release code is correct.
Compose, by the ignition key, the figure 2 (turn on and off the ignition key for 2 times consecutively).
If the function corresponding to the number of the LED flashing is disarmed, a beep of acute tonality will be heard.

If the function corresponding to the number of the LED flashing is activated, a beep of deep tonality will be
heard.