Page 8 of 9
USER GUIDE (CONTINUED)
12. 1 The password must be 4 to 6
alpha-numberic characters.
Enter new password and
verify it then press “Save”.
13. Press Fig.8 “Restore factory
defaults” to restore your settings
(only the light name and
password) to the original
conditions.
13.1 Keep pressing the “reset” button
on the light for 5 seconds, the
light will flash three times.
Then press “Back” button.
Note: The photo’s settings
can’t be restored by
using this function.
Note: 1. Manual control and App control independently.
2. The function which is executed is the lastest
settings.
3. When call again after power cut, the function will
revert to phsical switch’s control on the lamp.
4. For achieving the best performance,make sure the
wall switch is in “ON” state (daytime and
nighttime).
5. Once the power fails, the light will revert to phiscal
switch’s control on the lamp.
Fig. 13
Fig. 13-1
Fig. 12-1
Range
Up to 70ft. (21.3m)(Varies with surrounding temperature)
Up to 240
29W
2600lm
120 VAC, 60Hz
Test, Auto,Customer setting,Manual
5s,1min,3min,5min
Iphone 4S or newer running IOS 8.0 x or later.
Android v4.4 or later
Phone must also have Bluetooth version 4.0 or later
Sensing angle
Electrical load - LED
Lumens
Power requirements
Operating modes
Time delay
Mobile device requirements