OPERATING THE UNIT - LIGHTING AND EXTINGUISHING
FOR YOUR SAFETY, READ BEFORE LIGHTING
WARNING: IFYOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY
RESULT, CAUSING PROPERTY DAMAGE, PERSONAL INJURY, OR LOSS OF LIFE.
A. BEFORE LIGHTING
, smell all around the unit
C.
Use only your hand to push in or turn the gas
control knob. Never use tools. If the knob will not
because some gas is heavier than air and will
push in or turn by hand,
DO NOT
try to repair it.
B. WHAT TO DO IF YOU SMELL GAS
explosion.
1. Shut off the gas to the appliance.
ame.
3. If odor continues, immediately call
your gas
MANUAL (MATCH) LIGHTING INSTRUCTIONS
1. STOP!
Read the safety information above.
Fig. 15-1
2.
Lay a lighted long-stem match on the surface of the
decorative media near the burner ring (do not hold the
match in your hand) (Fig. 15-1) or use a lighted long-
necked butane lighter (Fig. 15-2)
3.
Push and slowly turn the control knob to the
ON
position (see Fig. 15-3). Your burner should light.
4.
Observe the flame height when lit. Flame should be
3 to 13 inches high (see Fig 15-4).
Apply match, then turn on gas
5.
If the burner does not light before the match goes out,
immediately turn the control knob to the
OFF
position.
Fig. 15-3
6.
gas, and repeat steps 1-4 above.
7.
If your burner fails to light again, turn the control knob
to the
OFF
position and contact your dealer or gas
supplier.
8. To extinguish your gas burner
, turn the control knob
ON
OFF
to the
OFF
position. Be sure the control knob is turned
fully off to avoid any gas leakage.
Fig. 15-2
Fig. 15-4
long-necked butane lighter
