14
Maverick Boat Group
3207 Industrial 29th St. • Fort Pierce, Florida 34946
(772)-465-0631
•
Pathfinderboats.com
manufacturing process. To attach a trolling motor, please go to your nearest Pathfinder
dealer. All trolling motors should be attached by drilling through the mounting plate
with a 13/64” drill bit and 1/4” tap and using 1/4” #20 machine screws. The plate is
designed to accommodate the mounting patterns of all trolling motor brands on the
market currently. See page 31 for optional trolling motor system with battery charger
and wire routing.
Battery Switch and Breaker Panel
Battery Switch and Breaker Panel
The battery switch and breaker panel
are located on the starboard side of
the helm seat. The top 80-amp
breaker is the main power for the
boat, which feeds the switch panel on
the helm and its associated
accessories along with engine power.
The remaining breakers are labeled
with the corresponding component
and amperage. When the boat is not
in use, it is recommended to leave
the battery switch in the off, “0’,
position to ensure that the main battery is not drained over the long term by minor
current flows.
All Pathfinders are rigged standard with a 36 volt trolling motor wiring system. In the
2400TRS the trolling motor batteries are located through the access door on the fwd
side of the head. In the head is the corresponding battery switch for the system.
Battery Access
The cranking battery is located in the compartment inside the leaning post. To access
batteries, open battery compartment doors located on the aft side of the leaning post.
