10
Using the DOG-e-walk without the leash
You want to train your dog without a
leash and teach certain commands?
No problem! The DOG-e-walk can be
used off-leash as a remote control
device.
Practice using the “Sit!” command
This exercise is based on the
assumption that your dog is familiar
with the command “Sit!”
1. In order to get the best results,
always position yourself so
that your dog can see you well.
Support your command by
pointing your finger when you say
“Sit!” (or by showing a flat hand
for the “Stay!” command).
2. Turn the DOG-e-walk on.
3. Give the command “Sit!”
4. If your dog doesn’t react
immediately to your command
(within two seconds), then
increase the volume on the
remote control. (You can also
control the strength by watching
the LED display.) Start with a weak
signal strength (where one or two
LEDs are lit).
5. If your dog now reacts to the
signal, then turn the volume off
(no LEDs will be lit).
6. Praise your dog.
7. As an alternative, you can also
give your dog a treat for good
behavior.
8. If your dog still doesn’t react to
your command, then increase the
pressure by turning the volume up
(where three to four LEDs are lit).
9. Now your dog notices that the
pressure is increasing and that
you want it to sit.
10. Give praise as soon as your
dog reacts positively to your
command. By doing this, you are
encouraging good behavior.
www.RollingTStores.com/dog-accessories/patento-dog-e-walk-all-in-one-trainer/
