User Manual IK 150 / 0031 e
© 1997 PAT GmbH · D-76275 Ettlingen · Hertzstr. 32 - 34 ·
)
++49 (0) 7243 709-0 · FAX ++49 (0) 7243 709-222 · Email: [email protected]
19
50 / 150 / 19_0031E.DOC / 19.03.1997 / Rev. C / rk.
Error Code
Error
Cause
Elimination
•
Defective length poten-
tometer
•
Replace length potentiome-
ter.
E06
Radius range ex-
ceeded or fallen be-
low angle range with
luffing jib operation
•
Maximum radius as speci-
fied in the load chart ex-
ceeded or fallen below
minimum angle due to luffing
down the luffing jib too far
•
Luff the jib to a radius or an-
gle specified in the load
chart.
E07
Faulty acknowledg-
ment of the overload
relay on the connec-
tion board.
The relay should be
energized, the 2nd
contact however is
indicated to be off, or
the 2nd contact is in-
dicated to be on
while the relay
should be de-
energized.
•
Overload relay or connec-
tion board are defective
•
Processor board defective
•
Replace connection board
•
Replace processor board.
E08
No acknowledgment
from the anti-two-
block relay
•
refer to E07
•
refer to E07
E10
Error in the length
measurement
•
With the boom retracted, the
signal "main boom length"
differs by more than 2 %
from the programmed value
for the basic length
•
Check length sensor of the
main boom
•
With the boom retracted, the
signal "length Tele I (+II)"
differs by more than 2 %
from the reference value 0
•
Check length sensor 2.
E11
Fallen below lower
limit value for meas-
uring channel "length
main boom"
•
Cable between central unit
and length sensor is defec-
tive or disconnected. Water
inside the plug of the
length/angle sensor
•
Check cable as well as
plugs, replace, if need be.
•
Length potentiometer is
defective
•
Replace length potentiome-
ter
•
Electronic component in the
measuring channel is defec-
tive
•
Replace LMI main board or
processor board.
E12
Fallen below the
lower limit value in
the measuring chan-
nel "pressure piston
side"
•
Cable between the central
unit and pressure transduc-
ers defective or water inside
the plugs
•
Check cable as well as
plugs, replace, if need be.
