PAT America DS 350, Operator'S Manual

Page: 42 / 46

Operator's Manual DS 350 / 1319
© PAT Rev. 7 06/18/01 // MO 191319_7.DOC
38
9 TROUBLESHOOTING
9.1 GENERAL
In case of a malfunction of the system, the display (1) will indicate a code that identifies the system malfunction.
The error codes listed in the Malfunction Table will identify various faults that can occur with the LMI. Following
the Malfunction Table are pages which explain each fault and describe the action which shall be taken to correct
the fault.
Faults within the electronic microprocessor shall be repaired by factory trained service personnel. When these
faults occur, the competent service organization shall be contacted.
9.2 MALFUNCTION TABLE
Error
Code
Error
E01 Fallen below the radius or above angle range
E02 Radius range exceeded or fallen below angle range
E03 Boom position is out of the permissible working area
E04 Operating mode not existing
E05 Prohibited length range
E18 Front outrigger overloaded
E83 Center Mid not fully extended
flashing % Telescope out of permissible sequence
NOTE:
If there is any Error Code displayed on the console which is not listed in the Malfunctions
Table you shall call the Local Distributor.


 

