2
3
WARNING
For your protection please read the following:
Water and moisture:
This device should not be used near water ( as per example, near a bathtub,
washbasin, kitchen sink, laundry tub, wet basement or swimming pool ). Care should be taken
such that objects do not have the opportunity to fall, and that liquid is never spilled onto or into
the device enclosure through openings.
Power Sources:
This device must be connected to a mains power source in strict accordance
with the supplied product owners manual. Please verify that the AC mains voltage specified in the
product manual matches those requirements indicated on the unit and the AC voltage provided to
your location by the power company. The product MUST be connected to a MAINS socket outlet
with a protective earthing connection.
Power Cords:
Pass Labs provides a power supply cord that meets all legislated requirements for
the market in which the product was originally sold. If you choose to substitute an after-market
product we urge you to choose one that is fully safety rated by the necessary local authority.
Power supply cords should be routed so that they are not likely to be walked on, abraded, or
pinched by items placed on or against them, paying particular attention to cords where they enter
plugs or exit from a device. Never under any circumstance insert a cut or damaged power cord
into a mains power socket. Cables should never be connected / disconnected with equipment
powered up. Failure to heed this warning may damage or destroy equipment.
Ventilation:
Power-amplifiers run warm, but you should be able to place your hands on them
without discomfort. You must allow for this heat in installation, by providing for free air
circulation around the product. Leave a minimum of 6” of space around the amplifier. The
ventilation should not be impeded by covering the ventilation openings with items, such as
newspapers, table-cloths, curtains, etc.
Other Warnings:
No naked flame sources, such as lighted candles, should be placed on the apparatus;
This amplifier is suitable for tropical climates under 2000m and ambient temperatures of 40
degress C or less.
Servicing:
To reduce the risk of fire, electrical shock or other injuries, the user should not attempt
to service the device beyond that which is described in the operating instructions. All other
servicing must be referred to qualified service personnel.
For Units With Externally Accessible Fuse Receptacle:
Unplug the device from all sources of
power before changing or inspecting any fuse. Replace fuse with one of same physical size, type
and rating as that specified by the manufacturer for that product.
Country Specific Warnings:
China: For use at altitude 2000m or lower.
Norway: Apparatet må tilkoples jordet stikkontakt.
Sweden: Apparaten skall anslutas till jordat uttag.
Finland: Laite on liitettävä suojakoskettimilla varustettuun pistorasiaan.
Denmark: Apparatets stikprop skal tilsluttes en stikkontakt med jord, som giver forbindelse til
stikproppens jord.
Quick Setup:
Unpacking your INT-25
The INT-25 is heavy - please make sure you have help to remove the INT-25 from the packing
and to place the amp where you want it.
Included in the box are a remote control, power cord and spare fuse. You will need these so
don’t throw them away with the empty box. In fact you should keep the empty box as well.
Place the amplifier close to where you intend to use it. Just leave enough access so you can
connect the inputs and speaker cables.
Plug in the amp into the AC. Turn on the AC power switch. At this point you should have the
LED display on. Push the “power” button on the faceplate a few times. The amp should cycle
on and off (display will come on and go off).
Turn the amp “off ” from the faceplate. Now you should be ready to connect your sources and
speakers.
Quick Connections:
Connect your sources to the inputs. There are three pairs of single-ended inputs.
The speaker binding posts can accept spades, banana plugs or bare wire. To ensure a good
connection when using banana plugs, make sure the bindposts are all the way in .