PAGE 4
SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE
Soundcaster
®
PROFESSIONAL AUDIO & SOUND
®
OPERATION PROCEDURES
IMPORTANT!
After unpacking the unit for the first time, please
charge the lead acid batteries for at least 10 hours
before any operation. The batteries were fully
charged in the factory before shipment. To charge the
batteries, just plug in the AC supply and charging will
start automatically. In the charging process, the
charging indicator will be flashing.
To Operate Using AC Power Supply
Switch on the main power supply switch.The AC
power supply is designed to provide the power for the
system while charging the batteries.
When the charging indicator is GREEN the batteries
are fully charged and non AC operation can now be
started. This main power supply DOES NOT switch
on the receiver modules.
To Operate Using the Rechargeable Batteries
Switch on the main power supply switch. When bat-
teries are charged, the power supply indicator will be
GREEN. When the power supply indicator is RED the
built-in batteries are weak. Please charge the batter-
ies first before using or you can also operate it while
charging. This main power supply DOES NOT switch
on the receiver modules.
To operate the casstte deck or CD player, please
switch on the TAPE / CD switch (DISABLED THIS
MODEL).
To Operate the Receiver Module
Switch on the power/ volume switch located on the
receiver module front panel. Adjust volume. (the mod-
ule and transmitter must be on the same frequency to
operate properly)
Operating the Wireless Microphone System
To use the wireless system, make sure that all vol-
ume knobs are set to minimum levels before turning
the unit on, switch on the receiver power/ volume
switch on the receiver control panel. Switch on the
corresponding matching wireless microphone trans-
mitter ( please refer to the operating instructions of
the individual transmitter ). When RF signal is being
received by the receiver, the receiver RF diversity sig-
nal indicator A or B on the control panel will light up.
Rotate the power/ volume control knob on receiver
control panel and the Master volume control clock-
wise to the desired levels.
To use the second wireless system, repeat the above
on the second receiver module.
Operating Wired Microphones
To use microphone one, simply plug in the micro-
phone cable connector into the XLR / Phono jack
combo connector on MIC 1 control panel. This unique
connector accepts either XLR or 1/4" male phono
jack connector. Rotate the volume control clockwise
on MIC 1 control panel and the Master volume con-
trol to increase the volume.
To use microphone two, simply plug in the micro-
phone cable connector into the XLR / Phono jack
combo connector on MIC 2 control panel. Rotate the
volume control clockwise on MIC 2 control panel and
the Master volume control to increase the volume.
Both wired and wireless microphones can be used
simultaneously utilizing the built-in mixer.
