+
+
PPN-MASTER IM40 MANUAL 10
9 PPN-MASTER IM40 MANUAL
PREPARING AND USE OF TOOL
FOR FIXING METAL CONNECTING PLATES
Caution: Use Paslode 35 and 40mm (1.35 to 1.57 inches)
Hardened nails only. Do not over drive Nail. Under side of
nail head should rest against Metal plate surface
ADJUSTING THE DEPTH OF DRIVE - THUMB WHEEL ROTATION
Metal Plate Surface
Counter
Sunk
Proud
INCREASE
DEPTH OF DRIVE
DECREASE
DEPTH OF DRIVE
ALWAYS WEAR
EYE AND HEARING
PROTECTION
TOOL FIRING SEQUENCE
1,000/Hour Max Fire/Cycle rate at 2 nails per second / -3°C to 40°C (27°F to 104°F)
BANG!
BZZZZZ
1
2
3
4
Depress work contact
probe
Actuate trigger, tool fires
Allow recoil, work contact
is released
Trigger released
CORRECT BATTERY OPERATION
ON/OFF SWITCH. Battery has 2 secure lock positions:
engaged and disengaged
OFF
OFF
ON
ON
Green indicates
charged battery
Red indicates battery
needs recharging
CORRECT TOOL OPERATING PROCEDURES
CORRECT NAIL LOADING PROCEDURE
APPLICATIONS
Slide nail strip into back of
Magazine
Nail on plate
Depress lever, then pull nail follower
back past nail strip
Hanger bracket
Multigrip
Caution: Always refer to timber
connector manufacturers fixing
instructions
Triplegrip
Gently release follower onto rear
of nail strip, to prevent collation
damage
Strap Brace
1
2
3
= 25 nails
Diameter: 3.15 to 3.75mm (0.120 to 0.150 inches)
Length: 35 to 40mm (1.35 to 1.57 Inches)
Head type: Flat
Coating: Mechanical Galv, Stainless Steel