STEP 2: Next,
pull the follower toward the rear of the
until the follower passes the last strip of
Release the follower and let the follower
push the nails forward into the nose of the tool.
When the follower reaches the reload area, marked
on the side of the magazine, you may insert a new
strip of nails. When the follower arrow reaches the
lockout area the tool automatically locks the tool to
prevent the tool from operating. To unlock the tool,
simply reload another strip of nails.
Depth of Drive Adjustment
Disconnect the air supply.
The depth of drive adjustment is done by turning the
adjustment wheel located below the trigger.
Clearing a Jam
An occasional problem you may encounter is a jammed
fastener. Because of the unique design of the Paslode
Finish Nailer, clearing a jammed fastener is easy:
1. Disconnect the air supply.
2. Pull the latch, releasing front guide. Pivot front guide
forward.
3. Clear jam, and push driver blade back up to its normal
position.
4. Close front guide and latch it. Check that work
contacting element moves freely.
TOOL OPERATION
Fasteners
The Paslode T250-16
S
Finish Nailer drives
Paslode
®
16 gauge fasteners designed to be used
with the tool. The use of fasteners that do not meet
Paslode standards could cause tool damage and
will void all warranty claims.
Loading Fasteners
STEP 1: Align the heads of the Paslode 16 ga.
(1.6
mm)
Finish
nails to the brad channel in the rear of
the magazine
and insert one or two strips. Push
the nails strips
forward.
5
Lockout Feature
The purpose of this feature is to prevent needless
blank cycling, which could mar woods and damage
tool components.
Ten (10) nails will be left in the
magazine when the follower reaches the lockout
area. When changing fastener length or loading
at the beginning of the work day, you should inspect
the magazine and nose for any fasteners left in the
tool.
These nails will not be visible unless you open
the nose of the tool.
magazine
fasteners.
–
–
+
