PASIAN Otello, User Manual

Page: 16 / 50

14
(figura13)
(figura14)
The installation of an insert on sliding guides is a simple operation, it is
necessary to fix the base of the insert to the base of the existing chimney,
using the appropriate plugs, it is important that the base of the chimney
must be perfectly flat, intact and structured in so that it can withstand the
weight of the insert.
The choice of dowels must be suitable for the material of the chimney on
which it is installed, must guarantee the right seal and the correct
alignment of the parts (recommended measures: 12-14 mm). Operations
to be carried out:
1.Place the insert in the fireplace and pull it out completely.
2.Mark the position of the fixing holes after having "centered" the insert
in the chimney.
3.Remove the insert, drill the holes and insert the sealing plugs.
4.Insert the insert into the chimney, remove it and insert the fixing screws
5.Close the insert paying attention to the control switch fixed at the rear.
3.5 ASSEMBLY OF AN INSERT ON SLIDING GUIDES
Make sure the insert is installed straight to avoid overloading the guides.
The seat where the insert is installed must be properly ventilated, prepared
with air intakes.