Release date: 09.12.17
rev 1.0 17
2 / 4
FIREWALL
INSTALLATION MANUAL
30 m
DIAGRAM 1 code CF0044UNUN61 FIRWALL CONNECTIONS WITH REMOTE CONTROL (STAND ALONE MODE)
1. Please identify the location of the original vehicle
OBD2 port (www.paser.it/firewall/location) and
then remove the connector from its housing;
2. Please connect the male OBD2 plug to the original
OBD2 socket (1);
3. Connect to a wire ignition
4. Please connect the Firewall OBD2 module to multi-
way connectors of the OBD2 harness of the kit;
5. Please connect the harness OBD2 socket of the kit
in the same place where it was connected to the
OEM plug.
INCLUDED
HOW IT WORKS?
The unit supplied with remote control follows this procedure for the activation / deactivation of Firewall. The remote control has 2
buttons, please refer to the diagram below:
BUTTON PRESS
FIREWALL STATUS
OBD2 READING
BUZZER
FIREWALL LED
A 1
OFF
POSSIBLE
2 BEEP
GREEN
B 2
ON
NOT POSSIBLE
1 BEEP
RED
A
B
Warning!
When Firewall is off (OFF) you can set it so that every turning on of the ignition, the unit emits 5 beeps: this setting allows the user
to know when OBD protection is OFF.
To set this mode, please connect the BLACK wire to an ignition positive.
HOW IT WORKS?
The version supplied as ignition configuration, it’s a stand alone module and allows the Firewall OBD2 managing by a sequence of 3 consecutive car ignition
activations. The procedure is the following:
Warning!
When Firewall is off (OFF) at every turning on of the ignition, the unit emits 5 beeps: this allows the user to know the OBD protection is OFF.
Also on this setting, it is possible to combine a remote control.
CONTROL PANEL TURNING ON
FIREWALL
STATUS
OBD2 READING
BUZZER
FIREWALL LED
3
OFF
POSSIBLE
2 BEEPS
GREEN
3
ON
NOT POSSIBLE
1 BEEP
RED
DIAGRAM 2 code CF0044UNUN41 FIREWALL CONNECTION WITH VEHICLE KEY (STAND ALONE ON / OFF MODE)
1. Please identify the location of the original vehicle
OBD2 port (www.paser.it/firewall/location) and
then remove the connector from its housing;
2. Please connect the male OBD2 plug to the original
OBD2 socket (1);
3. Connect to a wire ignition
4. Please connect the Firewall OBD2 module to multi-
way connectors of the OBD2 harness of the kit;
5. Please connect the harness OBD2 socket of the kit
in the same place where it was connected to the
OEM plug.
FIREWALL OBD2
SOCKET
INSTALLATION
INSTALLATION
FIREWALL OBD2
SOCKET