Rotary Motion Sensor
Model No. CI-6538
24
®
straight down the middle of the groove on the clamp-on Super Pulley. (see
Figure 2.4)
5.
Place the disk directly on the
pulley as shown in Figure 2.5.
6.
Place the mass ring on the disk,
inserting the ring pins into the
holes in the disk as shown in
Figure 2.5.
Procedure
Measurements for the
Theoretical Rotational Inertia
1.
Weigh the ring and disk to
find their masses and record
these masses in Table 2.1.
2.
Measure the inside and outside diameters of the ring and calculate the
radii,
R
1
and
R
2
. Record in Table 2.1.
3.
Measure the diameter of the disk and calculate the radius,
R,
and record it
in Table 2.1.
Figure 2.4: Super Pulley position
Clamp-on
Super Pulley
3-step Pulley
thread
Figure 2.5: Setup for
Disk and Ring
mass ring
clamp-on
Pulley
Rotary Motion
Sensor
Mass of ring
Mass of disk
Inner radius of ring
Outer radius of ring
Radius of disk
Table 2.1: Theoretical Rotational Inertia