INITIALIZING
After receiving your PAS Vr. it is important to follow these steps:
[1]
Install Battery
Unpack all the parts shipped with your PAS Vr. Remove
the battery cover and check for a single 9-volt battery.
Install if needed and replace the battery cover.
[2] Turn System On
Slide the power switch to the "on" position (on left side of
device). The red lamp should appear at the top/center of
the display.
Wait two (2) minutes for unit to initialize.
[3] Heater
The heater automatically comes on whenever the system is
on. The orange heater lamp should appear (lower right
corner of display).
Wait about two (2) minutes
or until the
heater lamp cycles off. The fuel cell heater cycles on and
off as necessary.
[4] Activate Sensor
Press, or tap, the black switch button and release
immediately. A small green bar lamp should appear at the
bottom of the display. No other bars should light. A yellow
pump light will appear at top left of display. After 4-5
seconds the pump light will automatically turn off.
The system check is now complete and you are now ready to practice the procedures
explained in this manual.
CAUTION! :
Many hand lotions, body creams, perfumes, and colognes, etc. contain
large amounts of alcohol. Whenever those containers are opened or lotion is used, large
amounts of alcohol may be released into the air. If you take samples of air using the
passive test mode, you may detect this ambient alcohol. To eliminate this problem, you
must clear the air with fresh (alcohol free) air or leave that particular area to get reliable
test results.
6
