Parweld DP323C, User Manual

Page: 18 / 30

www.parweld.com
10. WELDING TABLE Use the table below to calculate
the welding current, according to the type of electrode
used: 11. CONNECTION FOR MMA WELDING The
Dinse connector is inserted by lining-up the key with
the groove and turning the connector in a clockwise
direction until it stops. The electrode clamp holder and
earth must be connected to the ‘+’ and ‘-‘ terminals,
according to the specifications of the electrodes used.
11. CONNECTION FOR MMA WELDING
The Dinse
connector is inserted by lining-up the key with the
groove and turning the connector in a clockwise
direction until it stops.
The electrode clamp holder and earth must be
connected to the ‘+’ and ‘-‘ terminals, according to the
specifications of the electrodes used.
This is carried out by stopping a while over the last
crater (i.e. the end of the welding seam), returning
slowly on the previously deposited seam for
approximately two centimetres and, only at this point,
moving the electrode away from the workpiece to turn
off the arc.
17