4
EN
⠗
For a good operation, don’t place the receiver near to sources of interference. Place the receiver in 1m dis-
tance from the ground and let at least 1m free space around the receiver.
TROUBLESHOOTING
Problem
Indicator status
Solution
No sound
Red transmitter indicator
doesn’t flash
Slide the POWER ON/OFF switch on the transmitter to
ON. Make sure that the batteries are properly inserted
with the correct polarity (+/-). If the batteries are cor-
rectly inserted, replace them by new ones.
The red POWER indicator on
the receiver is OFF
Check if the mains adaptor is plugged correctly into
the mains outlet and the DC socket. Make sure that the
mains outlet supplies the proper voltage
The signal indicators A/B on
the receiver are glowing
Increase the volume on the receiver. Check the output
connections from the receiver to the external equip-
ment
The signal indicators A/B
on the receiver are off. The
POWER indicators on the
transmitter and receiver are
glowing
Make sure that the frequencies of the receiver and the
transmitter match.
Move the transmitter closer to the receiver
Distortion level in-
creases gradually
The signal indicators A/B on
the receiver and LOW BATTE-
RY indicator on the transmit-
ter are glowing
Replace transmitter battery
Bursts of noise or
other audible radio
signals are present
Signal indicators A/B are on
Identify potential sources of interference (other RF
sources) and turn off, remove or use a wireless system
operating on a different frequency
Momentary loss of
sound as transmitter
is moved around the
performing area
Signal indicators A/B on the
receiver are off when the
sound is lost
Reposition receiver and perform walk-through test
again. If audio dropouts persist, mark “dead” spots and
avoid them during performance
SYSTEM SPECIFICATIONS
RF Carrier frequency range ......................................................................................... 863.2MHz & 864.8MHz
Max. RF emission ..............................................................................................................................7.14dBm
Operating range ............................................................................................................................30m typical
Audio frequency response ................................................................................................ 40-15,000Hz ±3dB
THD .......................................................................................................................................................<0.5%
RECEIVER SPECIFICATIONS
Input power .............................................................................................
5V𝌃 1A via supplied mains adaptor
Signal/noise ratio ................................................................................................................................. >80dB
Border upon channel rejection ............................................................................................................. >80dB
Image & spurious rejection .................................................................................................................. >80dB
Receiving sensitivity ............................................................................................................................ >5dBu
MICROPHONE SPECIFICATIONS
Power requirements ....................................................................................................
2 x 1.5V𝌃 AA batteries
Modulation type ....................................................................................................................................... F3E
Electric products must not be put into household waste. Please bring them to a recycling centre. Ask your local autho
-
rities or your dealer about the way to proceed.
