Partner PM-15, User Manual

Page: 6 / 22

2
Contents of packing
2
Prior to taking into operation your PM15 monitor, please check whether the following parts are
included and undamaged:
1 CD with touchscreen driver
1 Adaptor
Installation of the PM15 Monitor
3
The following steps are necessary for the device to function properly:
Switch the computer OFF. 1.
Connect the PM15 monitor to the computer. (For best results, set the computers screen resolution to 2.
1024x768).
Switch your computer and the monitor back ON.
3.
Adjust the display for the graphic card in the computer by means of the On Screen Display (OSD) 4.
Auto Adjusting feature. This step is important for getting the best picture quality. (section 4.1)
(Touchscreen Monitor Only) Install the touchscreen drivers for the corresponding operating system 5.
(chapter 6).
NOTE
The PM15 must be used with the power adaptor provided.
Cable Installation 3.1
The installation of the cables must be done with the computer switched off. Begin by connecting the
VGA cable, the RS232 or USB cable, audio cable then the power cable.
Once connected, turn the PM15 monitor ON. After about 3 seconds, you should see the LED on the
front panel light up green followed by an image on the screen.
IMPORTANT
If the computer is in suspend or standby mode the LED will
be red. If the SVGA cable between the Monitor and computer
is disconnected, the LED lights up red.
1 PM15 Monitor