-- 4 --
and seek medical attention. An antivibration
system does not guarantee the avoidance of
these problems. Users who operate power tools
on a continual and regular basis must monitor
closely their physical condition and the condition
of this tool.
WHAT IS WHAT?
1. Throttle trigger
10. Lower blower tube
2. STOP switch
11. High--speed nozzle
3. Primer button
12. Elbow tube
4. Start lever
13. Vacuum bag
5. Fuel cap
14. Upper vacuum tube
6. Starter rope
15. Lower vacuum tube
7. Vacuum handle
16. Throttle position lever
8. Spark plug
17. Instruction manual
9. Upper blower tube
WHAT IS WHAT?
17
14
12
15
10
11
9
8
2
1
6
3
5
16
4
7
13
ASSEMBLY
CARTON CONTENTS
Check carton contents against the following list.
S
Blower
S
Upper blower tube
S
Lower blower tube
S
High velocity nozzle
S
Elbow tube
S
Vacuum bag
S
Upper vacuum tube
S
Lower vacuum tube
S
Screw for vacuum tube assembly
NOTE:
It is normal for the fuel filter to rattle
in the empty fuel tank.
ASSEMBLY
WARNING:
Stop engine and be sure
the impeller blades have stopped turning be-
fore opening the vacuum inlet door or at-
tempting to insert or remove the vacuum or
blower tubes. The rotating blades can cause
serious injury. Always disconnect the spark
plug before performing maintenance or ac-
cessing movable parts.
WARNING:
If received assembled,
repeat all steps to ensure your unit is properly
assembled and all fasteners are secure. Fol-
low all safety information in the manual and on
the unit.
D
A standard screwdriver is required for as-
sembly.
BLOWER ASSEMBLY
BLOWER TUBE ASSEMBLY
1. Align the rib on the upper blower tube with
the groove in the blower outlet; slide the
tube into place.
NOTE:
The tube clamp bolt must be loose
enough to allow blower tube to be inserted in
blower outlet. Loosen the bolt by turning coun-
terclockwise (do not remove nuts).
