ParTech SoliTechw2 IR Series, Instruction Manual, Page: 9 / 26

SoliTechw² IR Sensor
1 SoliTechw² IR Sensor Configuration
Before attempting to configure the SoliTechw² IR sensor, please read the user manual that came with your monitor.
The monitor manual will introduce you to the basic set-up of the monitor, and
will familiarise you with the monitor menu structure and buttons.
The monitor leaves the factory with no sensors pre-installed.
Assuming the monitor has been physically connected to a sensor, the next
step is to register and configure the sensor before any measurements can be
made. A single sensor may provide one or more measurements. We advise
only adding one sensor at a time. Once the first sensor has been registered,
connect the second and register again. Repeat for any additional sensors.
All sensors must be registered to the monitor in this way, even if they are
different types.
Please note that live measurements are not available until the sensor
Configuration stage has been completed.
1.1 Sensor Config
From the Measurement screen press to access the MAIN MENU.
From the MAIN MENU screen, select SENSOR CONFIG by pressing , and
press to accept.
1.2 Sensor Status
This option allows the user to review the
current status of the 8 sensor channels,
these will all be set to disabled until a
sensor is added.
Once a sensor has been installed the
display will be updated to indicate the
sensor type installed and it's status.
1.3 Add Sensor
From the MAIN MENU screen, select SENSOR CONFIG by pressing and
press .
The SENSOR MENU should be displayed. Press to highlight ADD
SENSOR, and press .
228655IM-Iss05 Issue Date 25/08/2020 Page 9 of 26