Parsun F60 BEL-D, Service Manual

Page: 94 / 112

89
2.
Extend the push rod completely.
3. Change the positive and negative wire connections.
4. Compress the push rod completely.
5.
Repeat steps 1 to 4 to move the push rod up and down for 4 to 5 times.
6.
Extend the push rod completely, remove the oil screw and observe the oil level.
7.
If necessary, repeat the above steps until the oil level is correct.
8. Install and tighten the oil drain screw.
Specified torque: 6.5 Nm
If the hydraulic lifting device needs to be vented when installed on the outboard outboard motor,
please follow the following steps.
1. Turn the hand control valve counterclockwise until it cannot turn.
1. Hand control valve
2.
Tilt the outboard motor completely upward and then lower it downward by its own
gravity. Repeat 4 ~ 5 times.
3. Turn the hand control valve clockwise until it cannot turn.
4.
Wait for 5 minutes to stabilize the oil.
5.
Press and hold the tilt switch until the outboard motor is fully tilted.
6.
Wait for 5 minutes to stabilize the oil.
7. Remove the oil drain screw and observe the oil level.
8. If necessary, repeat the above steps until the oil level is correct.
9.
Install and tighten the oil drain screw.
Specified torque: 6.5 Nm