Parsun F15HP, Installation & Operation Demo

Page: 33 / 39

Warming up engine
CAUTION
2. Check for steady flow of water from the cooling water pilot hole.
CAUTION
1.After starting the engine, place the gear shift lever in neutral. For
approximately the first 3 minutes after starting, warm up the engine by
operating at one fifth throttle or less. Otherwise, will shorten engine life.
If the choke knob is left pulled out after the engine starts, the engine will stall. In the
temperatures of -5
℃
or less, leave the choke knob pulled out fully for approximately 30
seconds after starting.
If water is not flowing out of the hole at
all times while the engine is running, stop
the engine and check whether the cooling
water inlet on the lower case or the
cooling water pilot hole is blocked.
If the problem cannot be located and
corrected, consult your PARSUN dealer.