INSTRUCTION REF: IN145
ISSUE No. 2
DATE 25.02.09
Page 3 of 13
www.parry.co.uk
GAS CONNECTION
The gas connection is ½” B.S.P.T. on the left hand side rear of the fryer. The supply pipe must not be less
tha
n ½”, an easily accessible isolation cock should be fitted in the pipework as close as possible to the
fryer. An approved flex may be used in conjunction with a straining cable.
MODEL PDGF FRYER
USER INSTRUCTIONS
The attention of the user is drawn to the current Gas Safety (Instructions and Use) Regulations in force.
This appliance must be used in accordance with these, also the need for regular servicing which must be
carried out by a competent and qualified person.
SAFETY NOTE
Some parts and surfaces of this appliance can get hot in use. It is the responsibility of the Kitchen
Supervisor to inform and warn every user of this and to ensure the user wears any necessary protective
clothing when operating the fryer.
LIGHTING INSTRUCTIONS
WARNING: DO NOT LIGHT BURNERS WHEN THE PAN IS EMPTY
1)
Open the compartment door, ensure the drain valves are closed and check the level of cooking oil
(between maximum and minimum markings). The oil required to fill the pan to the correct level is 12
litres per pan.
2)
Turn on the gas supply.
3)
Turn the thermostat to OFF position.
4)
Press the pilot knob (A) in and rotate anti-clockwise to igniter position
Ignite pilot. If pilot fails to ignite, repeat the procedure.
5)
After the pilot is lit, hold knob in for 20-30 seconds to ensure pilot flame is fully established.
6) Release the knob and turn fully anti-
clockwise to ‘ON’ position. If appliance fails to operate, repeat
steps 3-5. The main burner is now controlled by the thermostat (B).
6)
To operate burner, turn thermostat knob (B) to required temperature.
NOTE: LIDS SHOULD NOT BE USED WHILST FRYING
SHUT DOWN OF THE FRYER
1)
When appliance is not required, turn thermostat (B) fully anti-clockwise to off position, this will leave
only the pilot lit ready for when the fryer is next required.
2)
To turn the unit off completely, turn the thermostat fully anti-clockwise and the pilot knob (A) fully
clockwise.
