INSTRUCTION REF: IN104
ISSUE No. 2
DATE 10.04.06
Page 2 of 15
TELEPHONE:
SERVICE (44) 01332 875665
FAX:
SERVICE (44) 01332 875536
WARNING
To avoid scratching the highly polished exterior surface of this equipment whilst
in transit, the protective film on the exterior surfaces has NOT been removed.
It is IMPORTANT that this protective film is peeled off before the equipment is
used.
IMPORTANT
PLEASE READ INSTRUCTIONS FULLY BEFORE USE
MODEL P6BO/2 COOKER
INSTALLATION INSTRUCTIONS
IMPORTANT- YOUR ATTENTION IS DRAWN TO THE GAS SAFETY REGULATIONS
CURRENT ISSUE. THIS APPLIANCE MUST ONLY BE INSTALLED AND USED IN A
WELL VENTILATED AREA.
This appliance must be installed by a competent person in accordance with these and any other
relevant regulations. Users, too should be aware of the regulations governing the use of gas
appliances, particularly with respect to the need for regular servicing.
Before installation check data plate on rear of splashback to ensure appliance is suitable for gas
supply available.
During installation provision must be provided for combustion air to the appliance through base
and rear of appliance. This should not be blocked at any time.
POSITIONING
The appliance must not be installed on or against combustible surfaces
– minimum clearances
must be:
Rear 150mm (6
”)
Sides 150mm (6
”)
from Hotplate to combustible material 1525mm (60
”) all local fire regulations should be
observed.
It is recommended that the appliance be sited below a ventilating hood preferably of the
extractor type, incorporating a grease filter.
Ensure appliance is level in two places. Place spirit level on shelf in oven, not on hotplate! All
four feet are adjustable, anti-clockwise to lower and clockwise to raise corner.
