Parry
-British Built for Purpose
IN272-3
4
Installation Instructions
ALL APPLIANCES MUST BE FITTED AND OR CONVERTED BY A REGISTERED INSTALLER, IN
ACCORDANCE WITH CURRENT REGULATIONS.
Before installation check data plate on rear of unit to ensure appliance is suitable for gas
supply available.
During installation provision must be provided for combustion air to the appliance through
base and rear of appliance. This should not be blocked at any time. This appliance should be
installed with adequate ventilation to prevent the occurrence of unacceptable
concentrations of substances harmful to health in the room in which it is installed.
POSITIONING
The appliance must not be installed on or against combustible surfaces – minimum
clearances must be:
Rear 150mm (6”)
Sides 150mm (6”)
Hotplate to combustible material 1525mm (60”)
All local fire regulations should be observed. It is recommended that the appliance be sited
below a ventilating hood preferably of the extractor type incorporating a grease filter.
The cooker is manufactured with four castors two of which are braked. Caution should be
taken when manipulating or moving the unit. The appliance should be attached to a wall with
a chain to restrict the movement of the unit once connected to the gas supply. When the unit
is installed in position the brakes should be on.
Ensure the appliance is level, by placing a spirit level on the shelf in the oven, not on the pan
supports. All four castors are adjustable. To alter the height of the unit, loosen the locking
grub screw with an M3 allen key.
Next turn the large nut on the wheel assembly to either raise or lower the unit. When you are
happy with the height, tighten the locking grub screw with the M3 allen key.
Locking Grub
Screw
Large Nut
