INSTRUCTIONS REF :IN111
ISSUE NUMBER : 3
DATE 10.08.15
PAGE 3 of 12
www.parry.co.uk
ENSURE THAT ALL THE SHELVES ARE FIRMLY IN PLACE
OPERATING
1.
Switch on power supply, the red lamp will indicate the power is ON
2.
Turn the temperature dial to the required heat setting, the green lamp will show indicated
power to the element and will extinguish when the desired temperature is reached.
This procedure will be repeated automatically as the thermostat maintains a constant
temperature.
For the best results from your new plate warmer, pre-heat the machine by turning the
thermostat to maximum (80°C) for approximately 20minutes. We recommend that you load
each shelf with a maximum of 20 or 40 plates, depending on the width of the machine, giving
a total machine load of 80 or 160 plates. Anything above our advised limits may reduce the
efficiency of this machine
Fitting a Different Plug
Should you need to replace the plug connect the wires as follows:
Green/Yellow wire
To EARTH terminal (
╧
)
Brown Wire
To LIVE (L) terminal of new plug
Blue Wire
To NEUTRAL (N) terminal of the new plug
Always fit the same value fuses as that originally supplied with your appliance. Only use
BS1362 approved fuses. As a guide only, appliances under 700w can have a 3 amp fuse (red)
and all others should have a 13 amp fuse (brown).
When disposing of an old plug (particularly the moulded type which has been cut from the
mains cord) always remove the fuse as the plug could be dangerous if ever inserted into a live
socket.
