We recommend you to install the Parrot RKi before installing the
UNIKA. Make sure the installation is correctly performed by checking if the
«Good bye» message is displayed when you turn off the ignition.
►
Refer to the documentation of your Parrot RKi for more information.
Installation of
the Parrot RKi
Selecting the
protocol
Use the DIP switches located on one side of the UNIKA to select the
protocol (resistive or CAN Bus / KBus) on which the vehicle is based.
Warning: Make sure the UNIKA is not powered before selecting the
protocol.
Installation
For your car set the DIP this way.
12V ignition is not provided.
Get the 12V ignition from the car.
Warning : Connect the ignition to the Parrot car kit if the vehicle is
based on a resistive or a K-Bus protocol. Don’t connect the ignition
if the vehicle is based on a CAN protocol as this signal is supplied by
the Parrot UNIKA.
Replace the MKi part on the UNIKA cable by the provided RKi part.
•
Connect the UNIKA between the Parrot RKi8400 and the vehicle wiring.
•
Installing the
UNIKA with
the Parrot
RKi8400
C12V
Summary of Contents for UNIKA
Page 4: ......
