Thank you for purchasing Parrot CK3000, the hands-free kit with voice recognition equipped with BluetoothTM radio tech-
nology
Parrot CK3000 offers you the following functionality:
- wireless radio connection with your telephone
- full duplex hands-free conversation with echo cancellation
- background noise reduction
- voice recognition
- automatic synchronization of your telephone directory *
- automatic disconnection of the car radio and connection to the speakers of your vehicle.
- pairing of up to 3 phones
* Only with Ericsson phone
If your CK3000 has been installed by a professional, go directly to the next section, the Connection Phase.
COMPONENTS OF PARROT CK3000:
The kit consists of the following components:
Electronic control box:
Do not install the control box close to the heater or the air-conditioning system.
Protect the control box from direct sunlight. Avoid enclosing the unit inside metal components - this will adversely affect the
quality of the Bluetooth connection.
Microphone:
The microphone should be directed towards the driver and should preferably be installed in between the visor
and the rear-view mirror.
Power cable.
IMPORTANT:
There are 3 wires: The 12 V permanent (Red), the 12V switched (Orange), and the earth (Black). The orange
wire must be connected to the 12V switched to enable CK3000 to go into standby mode.
Do not connect the orange wire to the 12V permanent. You run the risk of discharging the battery of the vehicle.
Buttons:
We recommend you install these in an easily accessible place, preferably on a clean, flat surface.
Connecting the mute cable:
Car radio with ISO sockets:
Disconnect the speaker harness and connect the connector 1 to the car radio and the con-
nector 2 to the socket of the speaker harness.
Car radio without ISO sockets:
Connect the wires one by one if the interface of the vehicle is not of the ISO type.
If the car radio has a "Signal Mute" input, connect the yellow wire to it.
ENGLISH
1
INSTALLATION
notice_eng.qxd 14/02/2002 15:39 Page 1
