Parrot Uncle F6267220V, Use And Care Manual

Page: 9 / 15

WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER
Installation & Operating Instructions for the
Parrotuncle Owner's Installation ,Manual
8
Remote controller
GENERAL INFORMATION
This remote controller is designed to separately control your ceiling fan speed and light ON/OFF.
There are four buttons (HI, MED, LOW, OFF) to control the speed of the fan and off.
The light button will control the light on and off.
The red indicator on the transmitter will light when one of the nine buttons is pressed.
INSTRUCTION OF INSTALLATION AND OPERATION
2.INSTALLING RECEIVER IN CEILING FAN
A. Safety precautions:
WARNING: HIGH VOLTAGE! Disconnect power by
removing fuse or switching off circuit breaker.
Do not use with solid state fans.
Electrical wire must meet all local and national
electrical code requirements.
Supply for fan must be 220/240 volt, 50Hz. Maximum
fan motor amps: 1.0, Maximum light watts: 180
incandescent or ballast.
Otherwise power can cause serious injury or death.
B. Installing receiver in fan:
a. emove power from the circuit.
b. emove ceiling fan canopy from the mounting
bracket.
c. isconnect existing wiring between ceiling fan and
Supply in electrical junction box.
d. ake connections as follows, using the wire nuts
supplied:
For Mounting Controller, Model RE-026
CONNECT TO
Green fan wire ....Bare supply wire
Brown receiver wire(AC IN L) ....Brown supply wire
Blue receiver wire(AC IN N) ....Blue supply wire
Blue receiver wire(TO MOTOR N) ....Blue fan wire
Brown receiver wire(TO MOTOR L) ....Brown fan wire
Black/Orange receiver wire(FOR LIGHT) ....Black/Orange light wire
CAUTION: Ceiling Angle Shall Not Exceed 30 Degrees,
FIG1
ACN ACL
ANT
COM FAN
LIGHT
INPUT
OUTPUT
RECEIVER
Use wire connecting nuts supplied with the fan
(FIG.3)
FROM POWER SOURCE
AC 220~240 VOLT 50Hz
.
Use wire connecting nuts
supplied with the remote
controller.
WIRE NUT
RECEIVER
CANOPY
(FIG.4)
ANTENNA PUT AT OUTSIDE
OF CANOPY BOX CAN GET
MORE OPERATION
DISTANCE
BLUE
INPUT
OUTPUT
BROWN
ANT
CANOPY
RECEIVER
BLUE
BROWN
BLACK OR ORANGE
1.SETTING THE CODES
To set the codes, perform the following steps:
A. Setting the codes on the transmitter:
a. emove battery cover. Press firmly on the arrow and slide battery cover off.
b. lide code switches to your choice of up or down position. (Factory setting is all up. Do not use this position. Use a
Small screwdriver or ball point pen to slide firmly up or down (Figure 1)).
B. Setting the codes on the receiver:
The Learn Key must be pressed with in 30 seconds, after pressing the Power button.
If not, please press the Power button to restart.
Keep pressing the button learn key in excess of 3 second it becomes a LEARN status.
The receiver can remember the last codes status .The light flash two times.
TRANSMITTER
LEARN
CODE
COM
CODE
F6267220V