WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER
Installation & Operating Instructions for the
Parrotuncle Owner's Installation ,Manual
9
If other fans or supply wires are different color, have this unit installed by qualified licensed electrician.
e. ush all connected wires up into junction box.
f. ay the brown antenna wire on top of the receiver, and put the receiver into the mounting bracket.
g. einstall the canopy on the mounting bracket.
h. estore power.
3. PERATING TRANSMITTER:
A. Install 1.5 volt battery(not included). (To prevent damage to transmitter, remove the battery if not used for a long time).
B. Store the transmitter away from excessive heat or humidity.
C. This remote control unit is equipped with roll code combinations. In order to prevent possible interference from or to
other remote units such as garage door openers, car alarm or security system. If you find that your fan and light kit go
on and off without using your remote control, simply change the code combination in your transmitter and receiver.
D. Operating the buttons on the panel of the transmitter.
3 key -for fan high speed.
2 key-for fan medium speed.
1 key-for fan low speed.
OFF key-for fan off.
LIGHT key-for light ON/OFF.
2hr
,
4hr
,
8hr
button to set the FAN sleep timer from
YOUR REMOTE NOW HAS FULL CONTROL OF THE FAN AND LIGHT.
OPERATION DISTANCE 20 FEET
TRANSMITTER
MODEL:
RE-011
Optional Wall Mounting for Transmitter Holder
Place in accessible area of your home, and screw the
transmitter holder into wall using the two screws
provided, slide hand unit into holder.
4. TROUBLE SHOOTING GUIDE
1. ails to operate
a. ower to receiver ?
b. eceiver wired correctly ?
c. an manual speed control in highest position ?
d. ight kit switch turned on ?
e. ood battery in the transmitter ?
f.
ode set at exact same positions in both transmitter and receiver ?
2. on
'
t operate at distance
If transmitter operates fan/light kit when up close, but not at 20 feet away.
Try placing the brown antenna wire higher, up through ceiling/outside the junction box.
NOTICE !
Your ceiling fan and light kit assembly must meet the following requirements:
1. o not use with solid state fans.
2. lectrical rating: 220V~240V 50Hz
MAX. Motor amps: 1.0
MAX. Light watts: 180-(incandescent, or ballast non-dimmer, or LED)
WARNING
TO REDUCE THE RISK OF SHOCK, THIS FAN MUST BE INSTALLED WITH A WALL CONTROL/SWITCH.
LR
03 1
.5
V
A
A
A
LR
03 1
.5
V
A
A
A
F6267220V
Summary of Contents for F6267220V
Page 1: ...CEILING FAN...
Page 15: ......
