17
4.
A1 and A2 mode will scroll on the screen for a total of 8 minutes for wood pellets and 25 minutes for corn or
wheat. Note that the Stop icon is accessible at all time. Once the startup period is over, the screen will indicate the
heat level 3-15.
Note: This is a mechanical device. Since it contains two fan motors and two auger motors, it is likely that
you will hear sounds from your appliance, these noises are normal.
5.
Selecting heat level: There is a 5 minutes time delay cycle when increasing or decreasing between each level
for wood pellet and twenty 20 minutes for corn or wheat.
Use the 16 holes burner. Select
WOOD PELLET
combustible (icon 7).
Recommendation: Open the air valve (only when unit is cold) to a minimum of 1/8” or 3 mm (see picture 3). The
air valve is located on the side of the combustion chamber. Remove the right side panel to access the air valve.
In case of ash fusion (clinker), increase the ash removal and maintain the fuel bed to 5
” or
12.7 cm
. Close the air
valve if the ash fusion persists.
Important: Lightly tighten the top threaded disc with your hands when changing the burner. Install the
ash box below the burner before installing the burner’s bottom threaded disc.
WARNING: If the burner only produces smoke, immediately stop the startup proce-
dure or normal mode by pressing the red icon on the key pad. Wait until the unit is
completely cold before putting it back in operation.
Fuel chart information
Paromax has no control over the quality or types of fuels available on the market
and will assume no liability for any malfunction related to the type of fuel used.
Image 3
WARNING: Never open the main door and the ash door at the same time, this
could cause a fire extinction and generate smoke in the stove.
Heat level
Fuel per hour
1
Approximate 1 lb - .45kg
2
Approximate 1.5 lbs - .68kg
3
Approximate 2 lbs - .91kg
4
Approximate 3 lbs - 1.36kg
5
Approximate 4 lbs - 1.81kg
Instruction to optimally burn wood pellets
Procedures steps for startup
