Parmco PD6-PSE-2 Installation And Operating Instructions Manual Download Page 12

Page: 12 / 14

Once the appliance has been installed, the power supply cable and the electrical socket should
be easily accessible.

The cable should not be bent or compressed.

If the power supply cable is damaged, it must be replaced by the manufacturer or its Technical
Assistance Service in order to prevent all potential hazards.

Attention

The followings should be checked before starting the dishwasher:
1 Whether the dishwasher is level
2 Whether the water inlet valve is opened
3 Whether there is leakage from the water inlet
4 Whether the power is correctly connected and switched on
5 Whether the inlet and drain hoses are bent or kinked
7 All packing materials and printings should be taken out from the dishwasher.

Please put this manual and extra serial number in a safe place as you will need these if your
dishwasher requires service.

Start of Dishwasher

9. Troubleshooting Tips

Error codes

This appliance will display error codes to warn you of possible malfunctions:

WARNING

If overflow occurs, turn off the main water supply before calling Parmco. If there is water in the base
of the dishwasher due to an overfill or small leak, the water should be removed before restarting the
dishwasher.

Advice regarding the first wash cycle

After the appliance has been installed, immediately before running the first wash cycle, completely
fill the powder dispenser and rinse aid dispenser.

Positioning the Appliance

Position the appliance in the desired location. The back should not rest against the wall behind it,
and the sides should not rest against adjacent of cabinets. The dishwasher is equipped with water
supply and drain hoses that can be positioned to the right or the left to facilitate proper installation.

Leveling the Appliance

Once the appliance is positioned, adjust the feet (screwing them in or out) to adjust the height of the
dishwasher, making it level. In any case, the appliance should not be inclined more than 2 degrees
off vertical.

NOTE:

The maximum adjustment height of the feet is 20 mm.

How to Drain Excess Water From Hoses

If the sink is 1000mm higher from the floor, the excess water in hoses cannot be drained directly
into the sink. It will be necessary to drain excess water from hoses into a bowl or a suitable
container that is held outside and lower than the sink.

Water Outlet

Connect the water drain hose. The drain hose must be correctly fitted to avoid water leaks.
Ensure that the water inlet hose is not kinked or squashed.

Syphon Connection

The waste connection must be at a height of between 50cm (minimum) and 100cm (maximum)
from the bottom of the dishwasher. The water drain hose should be fixed by a hose clip.

Possible Causes

Water drainage malfunction

Door open

Water inlet

Water drainage

Temperature sensor

Overflow/leakage

Water leakage

Heating element

The door is opened when the
dishwasher is operating

Water inlet malfunction

Temperature sensor malfunction