Parmco In-bench 600mm, Installation And Operating Instructions Manual

Page: 9 / 26

7

The Downdraft can be installed with the motor mounted remote (in another position) using
Parmco’s mounting and ducting accessories.

If the Motor is mounted remotely, a power supply from the control switch is required at that
place.

Fit the Grille into the Surround.

Plug the motor into the power socket.
IN ‐ BENCH WITH CONTROLS
Power Supply
A conventional 3 pin power out let should be provided under the bench to supply power to this
unit
Cut Out Dimensions
Cut out for the In ‐ Bench Downdraft With Controls should be 475mm x 114mm.
Detailed Instructions

Mark out the cut out and cut the bench to the appropriate size.

Install the Surround Carrier into the cut out and secure.

The Airbox is symmetrical, and should be installed in the bench with the motor hole on the
required side and to the rear of the Carrier.

Place the top Surround on top of the Airbox and secure to the Airbox by means of two screws
provided.

Mount the Motor on the airbox and do up the 4 nuts working down through the top of the
Downdraft ensuring that the air seal is complete.

The Downdraft can be installed with the motor mounted remote (in another position) using
Parmco’s mounting and ducting accessories.

Fit the Grille into place in the Surround.

Vent the Downdraft either to the rear or through the floor.

Plug the Downdraft Motor into the socket on the speed controller and the Power lead into the
power outlet.
SIDE RISER
Specific Electrical Requirements
A conventional 3 pin wall mounted power outlet under the bench is all that is required.
Parts Supplied

Airbox mounted on the bench. Needs to be fully supported at both ends.

Riser column which rises above the bench when activated.

Surround (hides the cut out in the bench).
The cover plate/s on the airbox must be removed before attaching the motor.