Parmco In-bench 600mm, Installation And Operating Instructions Manual

Page: 10 / 26

8

Motor unit can be mounted on either side of the airbox or remote mounted using Parmco’s
mounting and ducting accessories.

Air Intake Cap.

Single intake ‐ strongly recommended when all the cooking is done to one side of the
Downdraft, i.e. when installed adjacent to a 600mm hob.

Double intake ‐ where the air can come in both sides of the Downdraft, i.e. when installed
between Parmco Domino units.
Prior to Making the Cut Out in the Bench

Determine the position of the airbox and surround on the benchtop. Finished size on bench is
500mm x 122mm.

Determine which side the motor should be fastened to the airbox.

Note that this will influence ducting requirements.

Pipes, nogs or other material in any walls or floor may have to be cut to accommodate the
ducting.
Cut Out Dimensions
Cut out for the Side Riser Downdraft should be 472mm x 96mm.
REAR RISER
General Instructions
This unit can be fitted as follows:

Adjacent to a 600mm Parmco gas/electric hob ‐ (excluding ceramic).

When being placed next to gas hobs, a 75mm wide space between the hob and the
downdraft unit is sufficient space for a wok or large frying pan to sit on the burner
without interfering with the operation of the Parmco Riser Downdraft.

Adjacent to any brand of hob (including Parmco ceramic) ‐ with a gap between the hob and
Parmco Riser Downdraft.

For Model P2R ‐ 3SS ensure if any air intake is not in use, it must be covered by its original cover
plate.
Specific Electrical Requirements

A conventional 3 pin wall mounted power outlet under the bench is all that is required.

The cover plate/s on the airbox must be removed before attaching the motor.

Motor unit can be mounted on either side of the airbox or remote mounted using Parmco’s
mounting and ducting accessories.

Air Intake Cap.

Single intake ‐ strongly recommended when all the cooking is done to one side of the
Downdraft, i.e. when installed adjacent to a 600mm hob.

Double intake ‐ where the air can come in both sides of the Downdraft, i.e. when installed
between Parmco Domino units.