9
CONNECTING DISPOSER TO MOUNT ASSEMBLY
1.
Line up disposer under mounting assembly. Guide hopper projections into mount
ring slots. Turn mount ring about ¼” to right so that disposer is temporarily
supported (see 3A).
2.
Turn mount ring and disposer until disposer elbow lines up with trap (see 3B).
3.
Turn mount ring to the right (clockwise) until it locks up tight. Tap the mount ring
ears with your hands until the lock position is achieved. Hopper projections must be
to extreme left of mounting slots (see 3C & 3D).
4.
If mount ring is hard to turn, you may add a small amount of petroleum jelly or liquid
soap to hopper projections. Run water and check for leaks.
ATTACHING DISCHARGE ELBOW
1.
Connect waste elbow to the disposer (see 4A) then connect bottom of the elbow by
tightening the slip nut (see 4B).
2.
If you are connecting to a dishwasher, refer to dishwasher connection on page 9. If
not, make sure all plumbing connections are tight and in accordance with all
plumbing codes and ordinances. Run water and check for leaks.
3A
3B
3C
3D
4A
4B