EN
Wing Assemby and Installation
Assembly
1. Install the vortex generators (
A
) in the wing channels (
B
) by using double-
sided tape (
C
).
CAUTION:
DO NOT crush or otherwise damage the wiring when
attaching the wing to the fuselage.
2. Slide the wing tube (
D
) in the hole in the left wing.
3. Slide the other end of the wing tube into the hole in the right wing until
both wings meet.
4. Install the wing cover (
E
) on the top of the wing, aligning the 4 holes as
shown.
Installation
1. Connect the aileron servos from the wings to the Y-harness connectors in
the fuselage. The left and right aileron servos can be connected to either
side of the Y-harness.
IMPORTANT:
Correct operation of the AS3X system requires connection of
both ailerons to the included Y-harness and the AILE channel of the receiver.
Tip:
A servo extension (PKZ5403, sold separately) may be installed in the re-
ceiver bind port so binding may be done through the battery door in the bottom
of the aircraft.
2. Attach the assembled wing and wing cover (
E
) to the fuselage using 4
screws (
F
).
3. Attach the left (
G
) and right (
H
) struts (marked L and R) under the wing and
fuselage using 6 screws (
I
).
IMPORTANT:
On the wings, tighten the 4 screws in the middle of the strut slots
so the wings are not pulled down (Fig J).
Disassemble in reverse order.
A
B
D
E
G
H
3 X 12mm (4)
2.5 X 10mm (6)
I
C
We recommend installing the Flaps (optional) in
the wing before installing the wing on the fuselage.
See the following page for detailed instructions.
Bag C
F
Bag C
Fig.
J
7
