EN
1. Loosely align the horizontal stabilizer unit (
A
) on
the rear of the fuselage.
2. Correctly connect the rudder and elevator servo
connectors to the marked connectors in the
fuselage (
B
).
NOTICE:
Ensure no wires are pinched or damaged
when the tail unit is attached to the fuselage.
3. Align and install the unit on the top of the rear
fuselage using 2 screws (
C
).
Tip:
Remove the rudder linkage from the rudder
servo arm so the right mounting plate can be
installed on the vertical fi n.
4. Install the tube (
D
) in the holes in the vertical fi n
(
E
) and in the top of the stabilizer unit.
5. Align and press the tail cone (
F
) on the rear of
the fuselage, then apply the included tape (
G
) to
the tailcone and fuselage.
6. Attach the vertical fi n to the stabilizer unit using
the left and right mounting plates (
H
) and
5 screws (
I
).
7. Put the Z-bend of the linkage (
J
) in the second
hole of the rudder servo arm (
K
) (the hole next
to the outermost hole).
8. Attach the linkage clevis (
L
) to the outer hole
of the rudder control horn (
M
). Ensure the tube
tightens the clevis on the control horn.
9. Where needed, disassemble in reverse order.
Attaching the Tail
B
C
D
A
E
F
H
I
J
L
M
K
G
2.5 X 8mm
2.5 X 8mm
10
