6. Technical data
Asynchronous motor
230 V~ 50 Hz
Output
1700 W
Operating mode
S1
Idle speed n
0
4800 min
-1
Carbide-tipped saw blade
ø 210 x ø 30 x 2,8 mm
Number of teeth
24
Tilting range
-45° / 0°/ +45°
Mitre cuts
0° to 45° to the left
Sawing width at 90°
205 x 65 mm
Sawing width at 45°
140 x 65 mm
Sawing width at 2 x 45°
(double mitre cuts)
140 x 40 mm
Weight
15 kg
Laser class:
2
Wavelength of laser:
650 nm
Laser output:
≤
1mW
Power supply for laser module:
2 x 1.5 V Micro (AAA) Batteries
Noise emission values
The saw’s noise is measured in accordance
with DIN EN ISO 3744; 11/95, E DIN EN
31201; 6/93, ISO 7960 Annex A; 2/95. The
machine may exceed 85 dB(A) at the
workplace. In this case, noise protection
measures need to be introduced for the user
(ear-muffs).
Idle speed
Sound pressure level L
pA
86 dB(A)
Sound power level L
WA
99 dB(A)
The values given are emission values and are
therefore do not necessarily depict the values
of a safe place to work. Although there is a
correlation (interdependence) between
emission and immission levels, it cannot be
reliably deduced whether or not additional
measures for caution are necessary. Factors
affecting the existing immission level at the
workplace include the duration of the
exposure, the characteristic of the workroom,
other sources of noise, etc., e.g. the number of
machines and other procedures in the vicinity.
The reliable values for the workplace can also
vary from country to country. This information
should however enable the operator to more
reliably estimate the dangers and risks
involved.
7. Before starting the equipment
7.1 General information
The equipment must be set up where it can
stand securely, i.e. it should be bolted to a
workbench, a universal base frame or
similar.
All the covers and safety devices have to
be properly fitted before the machine is
switched on.
It must be possible for the saw blade to run
freely.
When working with wood that has been
processed before, watch out for foreign
bodies such as nails or screws etc.
Before you press the ON/OFF switch check
that the saw blade is fitted correctly.
Moving parts must run smoothly.
Before you connect the equipment to the
power supply make sure the data on the
rating plate are identical to the mains data.
7.2 Assembling the saw (Fig 1-3, 5-6)
To adjust the turntable (16), loosen the
locking grip (13) by approx. 2 turns, which
frees the turntable (16).
To release the saw from its bottom position,
apply light downward pressure to the
machine head (5). At the same time pull the
safety pin (25) out of the motor mount. Turn
the safety pin (25) through 90° so that the
saw remains unlocked.
Swing the machine head (5) up until the
release lever (3) latches into place.
Fit the clamping devices (8) on the left
and/or right side of the fixed saw table (17).
Undo the locking screws for the workpiece
support (10).
GB/IE/
CY
16
Anleitung_4300696:_ 10.07.2009 12:31 Uhr Seite 16
