Parkside PSTDA 20-LI B3, Translation Of The Original Instructions

Page: 13 / 140

13
GB CY
Be sure to always use the correct
saw blade for the material.
Removing the saw blade
1. Hold the saw blade fi rmly (16/17).
2. Turn the clamping lever (28) as far to
the left as possible and hold it fi rmly in
this position.
3. Remove the saw blade (16/17) from
the chuck (10).
4. Release the clamping lever (28).
Removing/attaching the
parallel guide
The parallel guide can be fi tted on
both sides of the device.
Attaching the parallel guide
1. Loosen the retaining screws (12) if nec-
essary.
2. Slide the parallel guide (19) through
the slide-in openings (11).
3. Retighten the retaining screws (12).
Removing the parallel guide
1. Loosen the retaining screws (12).
2. Pull the parallel guide (19) out of the
slide-in openings (11).
Removing/attaching the
tension tear protection
Removing the tension tear protec-
tion
1. Press the tension tear protection (21)
away from the recess ( 29) in the
slide shoe (20).
Attaching the tension tear protec-
tion
2. Press the tension tear protection (21)
into the recess ( 29) in the slide
shoe (20).
Operation
Switch off the device and re-
move the battery before car-
rying out any maintenance
work.
Ensure that the ambient tem-
perature does not exceed
50 °C or fall below -20 °C
during work.
Switching on and off
The speed can be smoothly adjusted with
the on/off switch (2). The more you press
the on/off switch (2), the higher the speed.
1. To start the device, press and hold the
safety switch (1) and press the on/off
switch (2).
2. To stop the device, release the on/off
switch (2).
Adjusting the mitre
angle
1. Loosen the hexagon socket screws (7)
with the Allen key (18).
2. Press the baseplate (5) slightly back-
ward.
3. Set the bottom plate (5) to the desired
position (-45° - 45°). A total of 6 levels
can be set (-45°, -22.5°, 0°, 15°, 30°
and 45°).
4. Slide the baseplate (5) forward into
one of the notches.
5. Tighten the hexagon socket screws (7)
with the Allen key (18).
The maximum mitre angle can only
be set on both sides if the protective
cover (15) is folded up or disassem-
bled (see “Attaching/removing the
protective cover”).