76 GB/MT
Trial run
NOTE
u
Always carry out a no-load trial run
before starting work and after every saw
blade replacement . Switch the product off
immediately if the saw blade is not running
smoothly, if considerable vibration occurs
or if you hear abnormal noises .
Working instructions
m
CAUTION! RISK OF INJURY AND
DAMAGE TO PROPERTY!
u
Wear gloves when handling the saw
blade . In this way, you avoid injury from
cuts .
u
Do not use any blunt or bent blades or
blades which are damaged in any other
way .
u
Before sawing the workpiece, check for
hidden foreign objects such as nails,
screws . These must be removed .
u
Always insert a suitable saw blade .
u
Secure the workpiece with the aid of
clamping devices on the workbench .
u
Apply only as much pressure as is required
for sawing . If there is excessive pressure,
the sawing blade may bend and break .
u
Switch the product off immediately if the
sawing blade jams .
Spread the saw cut out and pull the blade
out carefully .
m
CAUTION! RISK OF INJURY AND
DAMAGE TO PROPERTY!
u
Always stand to the side of the product
when working .
u
Always make sure that the workplace is
well ventilated .
u
Avoid over-stressing the product while
working .
Regular cuts
¾
Verify the saw blade is not touching the
workpiece . Then, switch on the product .
¾
Apply the base plate 4 to the workpiece .
¾
Use even pressure, advancing at a steady
pace when making your cut . You can make
horizontal, diagonal, or vertical cuts .
¾
When you are finished: First, switch off the
product . Then, pull the saw blade out of the
workpiece .
Plunge cuts
(Fig . J)
¾
Plunge cuts are very challenging and are
associated with a higher risk of injuries . Only
use this technique if you are familiar with it .
¾
Plunge cuts may only be carried out in soft
materials such as wood or plasterboard and
with short blades (max . length 150 mm) .
There is a risk of kickback and personal
injury .
¾
Place the front edge of the base plate 4 on
the workpiece so that the saw blade does
not touch the workpiece .
¾
Turn the product on . Let the saw blade slowly
plunge into the workpiece .
¾
When the workpiece depth has been cut
through, continue sawing as usual .
Summary of Contents for PSSAP 20-Li B2
