![background image](http://html1.mh-extra.com/html/parkside/psg-50-a1/psg-50-a1_operation-and-safety-notes_758603008.webp)
9
GB/IE
cutting edges are less likely to jam and are
easier to control.
g)
Use the electrical power tool, accesso-
ries, inserted tools etc. in accordance
with these instructions and advice, and
the stipulations drawn up for this par-
ticular type of device. In doing this, take
into account the working conditions
and the task in hand.
The use of electrical
power tools for purposes other than those in-
tended can lead to dangerous situations.
Safety instructions for
motor carving devices
In order to avoid injury, fire and health
hazards:
Secure the work piece. Use clamping
devices / a vice to hold the work piece.
It is then held more securely than with your hand.
Wear protective goggles!
There is a danger of injury from
splintering materials flying into your
eyes
etc.
Wear a dust mask!
During pro-
longed working with wood and par-
ticularly if materials are processed
which produce dusts that are hazardous to the
health.
Do not soak materials or areas which
are to be worked on with solvent-con-
taining liquids.
Shaving of the materials may
produce harmful / toxic vapours.
Material containing asbestos must not
be processed with this device.
Asbestos
is a known carcinogen.
Under no circumstances should you
prop up your hands next to or in front
of the device or the area to be worked
on.
There is a danger of injury from the very
sharp attachment tools.
Always route the cable towards the back away
from the device.
In cases of danger remove the plug from the
socket immediately.
Original Accessories /
Additional Equipment
Use only the accessories and additional
equipment referred to in the instruc-
tions.
The use of tools or other accessories
which are not recommended in the instructions
may represent a risk of injury.
Operation
Turning the Device On / Off
Insert the mains plug into a socket.
Switching on:
Press the ON / OFF switch
1
to the “I”
position.
Switching off:
Press the ON / OFF switch
1
to the “0”
position.
Inserting / Replacing Blades
WARNING!
DANGER OF INJURY!
Before performing any work on the device, turn the
device off and remove the mains plug.
WARNING!
DANGER OF INJURY!
The
carving blades have a very sharp edge.
During assembly and the final check
of the blade you should wear ap-
propriate protective gloves.
The selection of the correct carving blade depends
on the specific application. The carving blades sup-
plied are suitable for the most common applications
(see Figures B - D).
Release the cap nut
6
with the key
8
in an
anticlockwise direction.
Remove the blade if necessary. Insert another
blade into the tool holder
5
as far as it will go.
Re-tighten the cap nut
6
with the key
8
in a
clockwise direction.
General safety advice for electrical power tools / Operation